P0032 b1s1 heater circuit high P0344 camshaft position sensor intermittent P1128 closed loop fueling not achieved P0340 cam position sensor circuit b1s1 O2sensor passenger side 1st one
Change Oil and Filter, Lube Chassis as Required, Check and Top Off Fluids, Check Air Filter, Set Tire Pressures, and Visual Safety Inspection.
OXYGEN SENSOR – Remove & Replace – V8,4.7L Eng Upstream,Right or Left,Each
CAMSHAFT POSITION SENSOR – Remove & Replace – Gas
TIMING CHAIN – Remove & Replace – V8,4.7L Eng All
James J. gave our service a 5 star review on 7/19/2024
P0455 evap large leak. P0442 evap small leak. No obvious evap leaks, need smoke test.
P0753 shift solenoid A electrical. No obvious external wiring issues, pan gasket has slight seep in area
TRANSMISSION SOLENOID – Remove & Replace – RWD
fix transmission line leak
A/C Performance Test – [Includes: Check condition of all belts and lines, gauge check, leak test, evacuate and recharge with reclaimed freon, and test system performance.
Arnulfo P. gave our service a 5 star review on 5/13/2024
P2509 ecm pcm power input signal intermittent – stored. P2146 fuel injector group 1 supply voltage circuit open – stored. Found voltage drop issues, battery terminals severely corroded. Driver side battery dropped to 6.04V during cold crank. Alternator cable end has corroded to nothing, broke during removal. Repaired and rebuild all corroded ends
Cleans and rebuild battery terminals, replace passenger positive terminal ends, cleaned and reseal terminals.
Solder terminal ends on both fusible link wires from Battery to Alternator Positive And From Battery to air Charge Heater.
Mac M. gave our service a 5 star review on 4/5/2024
Remove cover. Remove old gasket material, drain old fluid. Inspect internals and reassemble with new gaske or rtv. Install new fluid to proper level. Road test vehicle for proper operation.
Dominick P. gave our service a 5 star review on 3/27/2024